![]() ![]() ![]() Use the Volume Down key to move to the “Wipe data/factory reset” option and press the Power button. Make sure your important data is backed up properly before doing a factory reset. However, this process will also delete all the data on your phone. If nothing is helping you, then a Factory data reset will surely fix the no command error. Here access the “Updater” option and then select the software file you had downloaded. If you faced no command error while flashing a custom ROM, then go to the “Apply update from external storage” option. Here select the available software update and press the Power button to manually install it. Use the Volume Down key to move to the “Apply update from cache” option and press the Power button to open it. If you are seeing this error particularly after a software update or while trying to flash a custom ROM, then here’s what you need to do: Now press the Power button and then press it again to confirm cache deletion.Īfterward, use the “Reboot Device” option in this list to restart the phone and see if no command error is fixed or not. In the recovery mode, press the Volume Down key and move to the “Wipe cache partition” option. This is the easiest solution that won’t cause any data loss, let’s hope it fixes the problem. Wipe cache partition to fix no command error Use Volume Up and Down keys to move up and down, and use the Power button to execute a command. Note: While in the recovery mode you can only use the physical keys to navigate. If you can’t open up recovery mode from no command error screen, then turn off the phone by taking the battery out and then try the above mentioned key combinations. Usually, this happens due to improper software installation or even a simple device cache error.īefore following these solutions, follow the above instructions to access Android recovery mode. ![]() If your phone is stuck in a boot loop with no command error showing up, then you can try a few solutions to fix it. Depending on your phone manufacturer, one of these combinations should fix no command error and open up recovery mode. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |